Biohythane production from pineapple peel using Methanosarcina mazei enhanced with palm oil mill effluent (POME) sludge in single-stage anaerobic digestion

Biohythane production via single-stage anaerobic digestion (AD) is an effective way for sustainable energy recovery from lignocellulosic biomass. In this paper, biohythane was produced through the AD process from pineapple peel waste substrate using purely cultured Methanosarcina mazei with the enhancement of palm oil mill effluent (POME) sludge as the inoculum. This study focuses on the effects of the lignocellulosic pre-treatment method, the addition of POME sludge into M. mazei culture medium as inoculum, and various operational conditions (food to microorganisms (F/M) ratios, temperature, pH) on gas production performances. The experimental results indicate that these parameters influenced the efficiency of biohythane production by producing the peak maximum biohythane production rate values (HPR_max) and (MPR_max), H₂:CH₄ = 1.93:0.67 L/L-d, and biohythane yield (HY) and (MY), H₂:CH₄ = 1.18:0.55 mL/L-substrate. This study demonstrates that biohythane gas (H₂ + CH₄ + CO₂) production from pineapple waste can be accelerated by M. mazei only with the enhancement of POME sludge through single-stage AD system under mesophilic batch process conditions.     

The choice of system boundaries for effective long-term management of phosphorus

Journal of Material Cycles and Waste Management - Material flow analysis (MFA) is a well-established tool for supporting decisions on nutrient management. This paper shows the importance of the...     

Packed in-tube solid phase microextraction with graphene oxide supported on aminopropyl silica: Determination of target triazines in water samples

On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L^?1) and low detection limits (1.1–2.9 ng L^?1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples.     

Urban wild meat consumption and trade in central Amazonia

The switch from hunting wild meat for home consumption to supplying more lucrative city markets in Amazonia can adversely affect some game species. Despite this, information on the amounts of wild meat eaten in Amazonian cities is still limited. We estimated wild meat consumption rates in 5 cities in the State of Amazonas in Brazil through 1046 door-to-door household interviews conducted from 2004 to 2012. With these data, we modeled the relationship between wild meat use and a selection of socioeconomic indices. We then scaled up our model to determine the amounts of wild meat likely to be consumed annually in the 62 urban centers in central Amazonia. A total of 80.3% of all interviewees reported consuming wild meat during an average of 29.3 (CI 11.6) days per year. Most wild meat was reported as bought in local markets (80.1%) or hunted by a family member (14.9%). Twenty-one taxa were cited as consumed, mostly mammals (71.6%), followed by reptiles (23.2%) and then birds (5.2%). The declared frequency of wild meat consumption was positively correlated with the proportion of rural population as well as with the per capita gross domestic product of the municipality (administrative divisions) where the cities were seated. We estimated that as much as 10,691 t of wild meat might be consumed annually in the 62 urban centers within central Amazonia, the equivalent of 6.49 kg per person per year. In monetary terms, this amounts to US$21.72 per person per year or US$35.1 million overall, the latter figure is comparable to fish and timber production in the region. Given this magnitude of wild meat trade in central Amazonia, it is fundamental to integrate this activity into the formal economy and actively develop policies that allow the trade of more resilient taxa and restrict trade in species sensitive to hunting.     

Precursors and potential sources of ground-level ozone in suburban Shanghai

• Air masses from Zhejiang Province is the major source of O₃ in suburban Shanghai. • O₃ formation was in VOC-sensitive regime in rural Shanghai. • O₃ formation was most sensitive to propylene in rural Shanghai. A high level of ozone (O₃) is frequently observed in the suburbs of Shanghai, the reason for this high level remains unclear. To obtain a detailed insight on the high level of O₃ during summer in Shanghai, O₃ and its precursors were measured at a suburban site in Shanghai from July 1, 2016 to July 31, 2016. Using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model and concentration weighted trajectories (CWT), we found that Zhejiang province was the main potential source of O₃ in suburban Shanghai. When the sampling site was controlled by south-western winds exceeding 2 m/s, the O₃-rich air masses from upwind regions (such as Zhejiang province) could be transported to the suburban Shanghai. The propylene-equivalent concentration (PEC) and ozone formation potential (OFP) were further calculated for each VOC species, and the results suggested that propylene, (m+p)-xylene, and toluene played dominant roles in O₃ formation. The Ozone Isopleth Plotting Research (OZIPR) model was used to reveal the impact of O₃ precursors on O₃ formation, and 4 base-cases were selected to adjust the model simulation. An average disparity of 18.20% was achieved between the simulated and observed O₃ concentrations. The O₃ isopleth diagram illustrated that O₃ formation in July 2016 was in VOC-sensitive regime, although the VOC/NO_x ratio was greater than 20. By introducing sensitivity (S), a sensitivity analysis was performed for O₃ formation. We found that O₃ formation was sensitive to propylene, (m+p)-xylene, o-xylene and toluene. The results provide theoretical support for O₃ pollution treatment in Shanghai.     

Comparison between UVA- and zero-valent iron-activated persulfate processes for degrading propylparaben

Conventional wastewater treatments are not efficient in removing parabens, which may thus end up in surface waters, posing a threat to aquatic biota and hu     

Electrocatalytic oxidation of PCP-Na by a novel nano-PbO2 anode: degradation mechanism and toxicity assessment

Environmental Science and Pollution Research - This study aims at investigating the electrocatalytic oxidation of sodium pentachlorophenate (PCP-Na) using a novel nano-PbO2 powder anode. The...     

Preparation and Characterization of Xylan Derivatives and Their Blends

Although hemicellulose is found widely in nature, it is currently under-utilized as a raw material for commercial applications. It would be desirable to find new uses for hemicellulose in order to add value to this agro-based material. A common type of hemicellulose is xylan, which is found in a number of wood species and in cotton. In this work we prepared cationic and anionic xylan derivatives and characterized them by ¹³C NMR, FT-IR, size exclusion chromatography (SEC), thermal analysis, and rheology. In particular, the ¹³C NMR spectra of carboxymethyl xylan (CMX) and quaternary ammonium-adducted xylan (QAX) were fully assigned with the help of samples with different degrees of substitution. SEC indicated that the beechwood xylan showed a bimodal molecular weight distribution, but with derivatization the distribution tended to become unimodal. Thermal analysis and rheology studies did not uncover any surprises; the solution of xylan and its derivatives exhibited mostly Newtonian behavior. The blends of CMX and QAX produced a precipitate at almost all ratios, indicating the formation of a polyelectrolyte complex. When cationic and anionic xylan samples were added together to paper, the paper dry strength increased. Thus, the combination of cationic/anionic xylan may be of interest in selected applications.     

Are older drivers’ driving patterns during an on-road driving task representative of their real-world driving patterns?

Abstract

Objective: The current study investigated whether older drivers’ driving patterns during a customized on-road driving task were representative of their real-world driving patterns.

Methods: Two hundred and eight participants (male: 68.80%; mean age?=?81.52 years, SD?=?3.37 years, range?=?76.00–96.00 years) completed a customized on-road driving task that commenced from their home and was conducted in their own vehicle. Participants’ real-world driving patterns for the preceding 4-month period were also collected via an in-car recording device (ICRD) that was installed in each participant’s vehicle.

Results: During the 4-month period prior to completing the on-road driving task, participants’ median real-world driving trip distance was 2.66?km (interquartile range [IQR]?=?1.14–5.79?km) and their median on-road driving task trip distance was 4.41?km (IQR?=?2.83–6.35?km). Most participants’ on-road driving task trip distances were classified as representative of their real-world driving trip distances (95.2%, n?=?198).

Conclusions: These findings suggest that most older drivers were able to devise a driving route that was representative of their real-world driving trip distance. Future research will examine whether additional aspects of the on-road driving task (e.g., average speed, proportion of trips in different speed zones) are representative of participants’ real-world driving patterns.